New England Maple Walnut Fudge - No Fail Recipe (2024)

FAQs

What is the secret to good fudge? ›

Fudge Didn't Set

If your fudge turned out super sticky, or it didn't set as it cooled, it probably never got hot enough. This mistake is super easy to avoid if you use a candy thermometer and cook the fudge to the temperature specified in the recipe (usually between 234 and 239°F).

The key to successful, nongrainy fudge is in the cooling, not the cooking. The recipe calls for heating the ingredients to the soft-ball stage, or 234° F, then allowing it to cool undisturbed to approximately 110° F.

Once the fudge has thickened and the nuts are added, pour the fudge into the prepared pan. Allow it to set at room temperature until firm, about three hours or overnight.

You have to control two temperatures to make successful fudge: the cooking temperature AND the temperature at which the mixture cools before stirring to make it crystallize. Confectionery experiments have shown that the ideal cooking temperature for fudge is around 114 to 115 °C (237 to 239 °F).

So, the key to smooth yet firm fudge, pralines, and fondant is to first bring the mixture to a high enough concentration and then let it cool off somewhat before starting to stir. And once you do start to stir, stir fanatically and without stopping for the finest, creamiest texture.

To fix it, you can reheat the fudge mixture over low heat and continue cooking until it reaches the proper temperature. Be sure to use a candy thermometer to monitor the temperature accurately. Alternatively, you can try to salvage chewy fudge by mixing it into ice cream or using it as a topping for desserts.

OPTION 4) If you think the reason it didn't set was because you didn't heat it to the right temperature, you could try putting it back into the pan and re-cooking.

Stir the ingredients to dissolve the sugar until the mixture comes to a boil. If your recipe uses milk, stirring will keep the mixture from curdling. But once it reaches about 236–238 degrees F/113–114 degrees C (the "soft-ball" stage), do not stir it or even shake the pan.

Fudge usually behaves this way when it's not cooked to a high enough temperature (due to oversight or a faulty candy thermometer). If your fudge is tough, hard, or grainy, then you may have made one of several mistakes: You may have overcooked it, beaten it too long, or neglected to cool it to the proper temperature.

What can I do with ruined fudge? ›

Good use of failed fudge: fudge that is too hard, too soft, too runny, too sugary, too chewy, etc. Proportions are as follows: for every 2 cups (roughly 1 pound yield) of any failed fudge that is not runny, you'll need 1 egg, ½ cup all-purpose flour, and ½ cup milk. If fudge is soupy, halve the milk (to ¼ cup).

The most common reason for graininess is because you began beating or stirring it while the fudge was still cooling. It's best to wait until it's cooled to somewhere around 110 to 113 degrees to begin stirring.

Secondly, the pot's material should allow for good heat distribution hence your top choice should be copper cookware or a pot with a copper core. Copper's exceptional heat conductivity offers unparalleled temperature control, an asset when working with finicky ingredients like sugar.

If the fudge is very soft and slightly chewy then it is possible that it did not quite cook to soft ball stage and next time the mixture should be cooked to a slightly higher temperature (soft ball is 112-116c/235-240F and a sugar or candy thermometer can help).

According to most recipes, the ingredients of fudge are cooked to what is termed in kitchen parlance the soft ball stage, that point between 234 and 240 °F (112 and 115 °C) at which a small ball of the candy dropped in ice water neither disintegrates nor flattens when picked up with the fingers.

Brush the sides of the pan with a wet brush at the beginning of cooking to dissolve sugar crystals stuck to the sides. Never stir the mixture during cooking or sugar could crystallize again. The mixture may seize and become grainy. Use a candy thermometer or conduct a cold water test to check if the fudge is done.

Cream of tartar is used in caramel sauces and fudge to help prevent the sugar from crystallizing while cooking. It also prevents cooling sugars from forming brittle crystals, this is why it's the secret ingredient in snickerdoodles!

Don't stir!

Once the fudge reaches soft-ball stage on the candy thermometer, remove from the heat and let the temperature drop to 110°F. Keep that spoon or spatula out of the pot until this happens. If you stir too early in the process, you'll make the sugar crystals too big and end up with grainy fudge.

If your fudge is soft or runny, it probably didn't come up to a high enough temperature while it was cooking. Put it back into the saucepan and add 1–2 US tbsp (15–30 ml) of 35% fat whipping cream. Stir the fudge as it heats, but only until the sugar in the chocolate is completely melted again.